Crystop Display Gmbh AutoSat 2 Control Manuel d'utilisateur télécharger pdf (Page 9)

AUTOSAT 2 CONTROL U S E R M A N U A L PAGE 9

3 Sequence of automatic satellite search

The AutoSat 2 Control satellite system is turned on with the “On / Off” button on the

control unit. After turn on, the satellite to be searched for will be shown in the display (factory

setting ASTRA1 or the last received). In the top right of the display 5 seconds are now

counted down, during which time you may call up the main menu via the “Menu” button.

If no button is pressed, the satellite search starts (LED next to the “On / Off” button goes

out).Once a satellite has been found, fine positioning is carried out. After this (LED lights up

again) the words “SATELLITE FOUND” are shown in the display and the aerial signal is

switched to the receiver.

Now 120 seconds of delay are counted down in the display. During this time the main menu

may be called or the next satellite may be searched for. If no button is pressed within 120

seconds, the control unit switches itself off.

If the receiver is set to a program of the requested satellite, the program will now be visible

on the TV set. Should this not be the case, there is a possibility, that the control unit has

found a different satellite. By pressing the “Sat” button, the search may be continued.

AUSTRALIAN version:

to take affect you have to press down this button for longer than five seconds.

If on the other hand, the satellite system has found the right satellite and you nevertheless

press the “Sat” button, then the requested satellite will not be found, since incorrect

positions for further searches are precluded.

Therefore first check for other programs on the satellite by stepping the receiver to other TV

stations for that satellite if no program is visible initially.

If you want to change to a different satellite after the control unit has switched itself off, you

must switch it on again first.

After switching off the satellite receiver, the LED next to the “On / Off” button (or on the

optional remote control) starts to blink, as a reminder, that the antenna is still extended. To

retract the antenna you must activate the control unit by pressing the “On / Off” button once

and then press it again to retract the antenna. On reaching the parking position, the AutoSat2

Control switches itself off completely.

You will find a detailed description of all functions on the following pages.

AUS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

Crystop Display Gmbh AutoSat 2 Control Manuel d'utilisateur Page 9